PSSO HSP-4000 MK2 SMPS Amplifier
PSSO HSP-4000 MK2 SMPS Amplifier PSSO HSP-4000 MK2 SMPS Amplifier PSSO HSP-4000 MK2 SMPS Amplifier PSSO HSP-4000 MK2 SMPS Amplifier PSSO HSP-4000 MK2 SMPS Amplifier

PSSO HSP-4000 MK2 SMPS Amplifier

969,00 €
Sisältää alv. 24.00 %

Stereo PA amplifier with integrated SMPS, 2 x 2000 W

+ 2 kpl
Toimitusaika 4 - 7 työpäivää
Tuotenumero 10451694
  • Stereo PA amplifier with class H circuitry
  • Low weight and height due to integrated switch mode power supply
  • Reliable power amp with high impulse stability for a wide range of applications (e.g. compact PAs, multi-way PAs, international concerts)
  • Limiter and speaker switch-on delay
  • 3 operating modes can be selected (stereo, parallel or bridged)
  • 2 calibrated level controls for precise level adjustment
  • Input sensitivity and limiter adjustable
  • LED VU meter and LEDs for activated protective circuit (protect), overload (clip), and signal per channel
  • LEDs for parallel and bridge mode
  • Complete protection set against short-circuit, overheat, clipping, overload, DC voltage and VHF signals
  • Highly efficient front-to-rear air routing
  • Electronically balanced inputs via XLR mounting jacks, with XLR feed-through outputs
  • Speaker outputs via lockable Speaker plugs and screw terminals
  • Rugged steel chassis with aluminum front panel
  • Rack installation with 2 units

Power supply:230 V AC, 50 Hz
Power output (RMS):
Stereo 4 ohms2 x 2000 W
Stereo 8 ohms2 x 1200 W
8 ohms bridged1 x 4100 W
Signal-to-Noise ratio:>80 dB
Total harmonic distortion:<0.1 %
Damping factor:>200
Voltage gain:32 dB
Slew rate:>20 V/µsec
Crosstalk:>70 dB
Input sensitivity:32 dB/1.0 V/0.775 V, switchable
Input impedance:20 kohms (balanced), 10 kohms (unbalanced)
Input connectors:2 x XLR
Output connectors:2 x Speaker, screw terminals, 2 x XLR feed-through output
Protection:Overheat, overload, short-circuit, over-current, DC voltage, softstart, VHF signals
Cooling:2 temperature-controlled fans, front-to-rear
Controls:Power switch, input attenuators, mode switch stereo/parallel/bridged, input sensitivity
LED indicators:parallel, bridge (globally), protect, clip, signal (per channel)
Construction:Steel chassis, aluminum front panel
Dimensions:483 x 505 x 89 mm

Rack installation with 2 U
Weight:14 kg
Power consumption:2000.00 1/8 power W
Power/channel (8 Ohm):1200
Power/channel (4 Ohm):2000
Frequency range:20 - 20000 Hz
Height:8,9 cm
Depths:50,5 cm
Width:48,3 cm